Xalkiadakis Logo

Free Shipping for orders over 40€

Delivery within 24 hours

PATTEX

Pattex Petrol Glue 50 gr

153525
PATTEX

Pattex Petrol Glue 50 gr

153525
74.40€/ΚΙΛΟ
3.72€
Add
 
74.40€/ΚΙΛΟ
3.72€
Add
 

Polychloroprene.

Store the product at room temperature, ensuring that the container is always tightly closed.

MULTICHEM SA, 1 Vasileiou Voulgaroktonou Street, Haidari, 124 62, Tel: 210 5776275

Apply Pattex Classic Liquid evenly on both surfaces (especially on the edges) with a notched trowel or short-bristled brush. Before bringing the two surfaces into contact, wait a short time for the solvents in the adhesive to evaporate. The evaporation time under normal humidity and temperature conditions (+18°C and +25°C) is approximately 10-15 minutes. Ensure continuous ventilation of the work area. Immediately after the solvents have evaporated, bonding is possible even after 120 minutes. Insufficient evaporation time of the solvents, especially on non-absorbent materials, may result in lower initial bonding strength. After evaporation of the solvents, a uniform adhesive film should remain on the surfaces. On absorbent materials or materials with large pores, it may be necessary to apply more than one coat of adhesive. Before joining the materials to be bonded, the adhesive film should be dry to the touch, not stick to the finger, or leave a "trace."

Polychloroprene.

Store the product at room temperature, ensuring that the container is always tightly closed.

MULTICHEM SA, 1 Vasileiou Voulgaroktonou Street, Haidari, 124 62, Tel: 210 5776275

Apply Pattex Classic Liquid evenly on both surfaces (especially on the edges) with a notched trowel or short-bristled brush. Before bringing the two surfaces into contact, wait a short time for the solvents in the adhesive to evaporate. The evaporation time under normal humidity and temperature conditions (+18°C and +25°C) is approximately 10-15 minutes. Ensure continuous ventilation of the work area. Immediately after the solvents have evaporated, bonding is possible even after 120 minutes. Insufficient evaporation time of the solvents, especially on non-absorbent materials, may result in lower initial bonding strength. After evaporation of the solvents, a uniform adhesive film should remain on the surfaces. On absorbent materials or materials with large pores, it may be necessary to apply more than one coat of adhesive. Before joining the materials to be bonded, the adhesive film should be dry to the touch, not stick to the finger, or leave a "trace."

* DISCLAIMER: Chalkiadakis SA, always respecting its consumers, strives to provide reliable information on its website, based on the data it receives from its suppliers. However, Chalkiadakis SA informs that there may be discrepancies between the information provided and that on product labels, for technical reasons that may be due to stock updates. The information presented on the website does not in any way replace the information on the product labels, and in case of any discrepancy, the information on the product labels always prevails. Consumers must check the information on the labels before purchasing and before consuming the product and always consume it according to the intended use defined by the supplier. In case of disagreement, the consumer expressly waives any right of appeal against Chalkiadakis SA.

Cart

Your cart is empty

© 2023 Χαλκιαδάκης all rights reserved